A large rock had become lodged in the jaw crusher. The toggle plate of the jaw crusher was supposed to break when uncrushable material passed through the crusher. The toggle plate did not break and did not act as a safety device. The crew tried to dislodge the rock with a backhoe tooth cut from another piece of equipment and attached to a chain.

The material is crushed between the two jaws, so the wear of the liner is the main problem of the jaw crusher. And the types of wear and tear are mainly divided into the following cases. Bruise wear. In the jaw crusher, the ore is crushed and reduced to the required particle size.

A jaw crusher with a pass-through preventing device which prevents a flat plate-shaped object from passing through without being crushed. Also disclosed is a jaw crusher with a tooth plate structure which is capable of effectively crushing a non-rigid object, for example, a lump of asphalt, without causing such an object to stick to the area between a cheek plate and a fixed tooth plate or a ...

In a double-toggle jaw crusher, the moving crusher jaw is driven by the eccentric shaft that moves the front and rear toggles up and down. Each shaft revolution causes the moving crusher jaw to close at the downstroke and open up during the upstroke. …

In crushers like C105 and C3055, the jaw die design on the ends is different. The lock-ing wedges on these crushers are located behind the jaw dies rather than at the top of the jaw die. Jaw dies can be allowed to wear until the thickness is 60 to 65 mm thick, or the teeth are worn flat. On other crushers the ends of the jaw dies are much thinner.